Auto-zone-control-systems ZoneView Plus Software Manual (Version 01C) Manual de usuario descargar pdf (Pagina 15)

ZoneView Plus

Computer Front End 9

Search For Units

Other ZoneView Plus operations are greatly simplified if the program knows what type of

unit to expect at each address location on the RS-485 communications loop. Before the

user can search for these units the controller installations must be complete and all units

communicating. To access this screen you must have entered your passcode and then

selected the Go OnLine selection located under the Communications menu. The search

screen is shown below.

Selecting the Search For Units menu assumes that all previous steps have been

completed and you are ready to begin communications with the controllers. This unit

search should be performed the first time you run the program and anytime you add a

new controller or remove a controller from the communications loop. Once this search

has been performed, the identified units will be stored on disk and you won’t need to

repeat this function. Select the Start button to initiate a search.

If you are using this computer to access remote job-sites, then this search should be

performed the first time you call a job-site. These identified units are saved to a file that

is based on the selected phone list number.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Sin comentarios

Auto-zone-control-systems ZoneView Plus Software Manual (Version 01C) Manual de usuario Pagina 15