Auto-zone-control-systems Auto-Zone CV-C Controller Installation Guide (Vers Manual de usuario descargar pdf (Pagina 17)

Auto-Zone CV-C

Section 2

Sequence of Operation 2-7

Heat Mode A heating demand is generated when the space temperature drops half the

amount of the Deadband Setpoint below the currently active Heating

Setpoint. The space is considered satisfied when it rises that amount above

the Heating Setpoint.

Fan Only Mode A Fan Only mode cause ALL outputs except for the fan to their inactive

state. It is exactly like the Off Mode except the fan is running. This mode

can be used to temporarily purge the space, etc.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Sin comentarios

Auto-zone-control-systems Auto-Zone CV-C Controller Installation Guide (Vers Manual de usuario Pagina 17