Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Manual de usuario descargar pdf (Pagina 12)

CommLink IV Technical Guide

Operator Interface

Prism II Setup Instructions

12. Click <Communications> again and select <Search

for Units>

13. The Search for Installed Units Window will pop up. Click

<Start> to start the search.

14. If everything is working correctly, Units Found on this

Loop should increment.

15. If Units Found on this Loop stays at zero, check the wir-

ing to the CommLink IV and the AHU/RTU

Controllers and/or read through these directions again to

make sure all steps were followed.

Prism II Setup

1. Open your Prism II software.

2. Click on the <Login> button and type in

your level 3 passcode (default “9288”).

Click <OK>.

3. If Prism II is online, click the

<ON LINE> button to make it go

<OFFLINE>.

4. Click the <Job-Site> button to open the

Job Sites Window.

5. Click on any empty location in the Job-Site Selection Win-

dow and then type in a job name in the Selected Location

box and press <Enter>.

6. In the Serial Port ﬁ eld, click on the pull down box and se-

lect the COM Port number that the CommLink IV is using.

7. In the Type of CommLink selection box, select the radio

button next to CommLink 4.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Manual de usuario Pagina 12