Auto-zone-control-systems USB-Link 2 Technical Guide, Installation Instructi Manual de usuario descargar pdf (Pagina 8)

USB-Link 2

Technical Guide

Prism 2 Setup Instructions

Conﬁ guring Prism 2 for the USB-Link 2

1. Insert your Prism 2 software CD and follow the steps in the

readme.txt ﬁ le to install the software.

2. The instructions will tell you to create a

Prism 2.exe shortcut on your desktop. Click

on this icon to open your Prism 2 software.

3. Click the <Login> button and type in the level

3 User Name and password (default is “admin,

admin”). Click <Login>.

4. If Prism 2 is online, click the

<ON LINE> button to make it go

<OFFLINE>.

5. Click the <Job-Site> button to open the Job

Sites Window.

6. Click on any empty location in the Job-Sites Selection

Window and type in a job name in the Selected

Location ﬁ eld. Press <Enter>.

Your job site name will now appear in the Job-Sites

Selection Window.

7. In the Serial Port ﬁ eld, click on the pull down box and

select the COM port number that the USB-Link 2 is using.

8. In the Type of CommLink selection box, select the radio

button next to “CommLink 5 or USB Link II”.

9. In the Network Conﬁ guration selection box, select the

mode for the USB-Link 2 you are using. If using stand

alone mode, select USB Link Stand Alone. If using network

mode, select USB Link Network. The position of the slide

switch on the USB-Link 2 must also be set to the mode you

are using (See Figure 3, page 10 for help in setting this

switch).

10. Click <Exit> to close out of the Job Sites Window.

11. Click the <OFFLINE> button to go

<ON LINE>.

Revised 10/24/14

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Sin comentarios

Auto-zone-control-systems USB-Link 2 Technical Guide, Installation Instructi Manual de usuario Pagina 8