Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Manual de usuario descargar pdf (Pagina 17)

IP MODULE

Technical Guide

CommLink IV LED Descriptions

Figure 18: CommLink IV LED Display

STATUS

RX-USB

TX-USB

LOOP

TX-CPU

RX-CPU

ACT-LAN

LNK-LAN

CONTROLS

CommLink IV

www.wattmaster.com

CommLink IV LED Descriptions

LOOP - Indicates communication activity on local controller

network. This LED ﬂ ickers off when data is exchanged with

controller network.

TX-USB - Indicates transmitted data status of USB

connection. This LED only ﬂ ashes if the CommLink IV is

directly connected to a computer via a USB port. It will not

ﬂ ash when using the IP Module for LAN or WAN

connections.

RX-USB - Indicates received data status of USB connection.

This LED only ﬂ ashes if the CommLink IV is directly

connected to a computer via a USB port. It will not ﬂ ash

when using the IP Module for LAN or WAN connections.

TX-CPU - Indicates transmitted data status. This LED

ﬂ ashes when data is sent to Prism 2 from the CommLink

IV using USB or Ethernet.

RX-CPU - Indicates received data status. This LED ﬂ ashes

when data is sent from Prism 2 to the CommLink IV using

USB or Ethernet.

ACT-LAN - Indicates activity on the local area network.

This LED ﬂ ashes on when LAN is transmitting and

receiving data and only ﬂ ashes if the IP Module is

installed and operating.

LNK-LAN - Indicates local area network is connected. This

LED is on when connected to LAN and only ﬂ ashes if the

IP Module is installed and operating.

1 2 ... 12 13 14 15 16 17 18 19 20

Sin comentarios

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Manual de usuario Pagina 17