Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Manual de usuario descargar pdf (Pagina 9)

IP MODULE

Technical Guide

CommLink 5 Baud Rate Setting

Setting the CommLink 5 Baud Rate

CommLink 5 Baud Rate Setting

The Baud Rate Switch Located On The Back Of

The CommLink 5 Housing Must Be Set Correctly

For Your Specific Application In Order For The

CommLink 5 To Function At Maximum Efficiency.

The Should Be Set To “High” In The

Following Situations:

You Are Using Only 2 Controllers, Only

GPC-XP Controllers, or Only VCB-X

Controllers On Your System.

The CommLink 5 Is Factory Set For Low Baud

Rate Applications.

Baud Rate

The Baud Rate Should Be Set To “Low” In The

Following Situations:

You Are Using Orion Controllers Or Are

Using Orion Controllers In Combination

With VCB-X or GPC-XP Controllers. For

Example, VCB-X or GPC-XP Controllers

With VCM-X or VCM Controllers.

MULTIPLE

HIGH

SINGLE

LOW

BAUDLOOP

R (+)

24V

GND

SHLD

T(-)

SERIAL #

Switch Set To High Baud

Rate (115,200)

Back of CommLink 5

HIGH

LOW

BAUD

Switch Set To Low Baud

Rate (Anything Less Than

115,200)

HIGH

LOW

BAUD

Figure 5: Setting the Baud Rate

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios

Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Auto-zone-control-systems IP Module Kit Installation Guide for the IP Module