Auto-zone-control-systems Prism 2 Graphical Interface Technical Guide (Versi Manual de usuario descargar pdf (Pagina 10)

STEP 2: JOB-SITE SET-UP

Prism 2 Technical Guide

Step 2: Setting Up Job Sites

The second step in the Prism 2 Setup procedure is to program the

speciﬁ c job-site access settings and desired initial displays for each

location.

Click on the < Job-Site> button located on the Top

Toolbar of the Prism 2 Main Screen. The Job Sites

Window will appear. (Figure 2)

NOTE: You must conﬁ gure each of the ﬁ elds in this window for

every one of your job sites.

Job-Site Name:

When you ﬁ rst open the Job Sites Window, the Job-Site Selection

Window will be empty. Click on an empty location. The Job-Site

List # will display the number you have selected. In the Selected

Location ﬁ eld, type a name for your job-site and press <ENTER>.

Figure 2: Job-Sites Window

Serial Port:

TCP/IP—If you are using TCP/IP communications, leave the

Serial Port field set at “No Port Selected” which is the default.

Serial or USB—If Prism 2 will be connecting directly to a

CommLink through the Serial or USB Port, select the port that you

have connected your CommLink to and enter 0.0.0.0 for the Node

IP Address. COM Port #9 is the maximum port number supported

by Prism, so if your USB port is #10 or higher, you will need to

manually force the port to a lower port number using the Device

Manager found in your Windows

Control Panel. This procedure

is documented in WattMaster’s CommLink IV and CommLink 5

Technical Guides.

Job-Site Set-Up

Revised 9/25/13

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Sin comentarios

Auto-zone-control-systems Prism 2 Graphical Interface Technical Guide (Versi Manual de usuario Pagina 10